Investigation the machining of the engineering polymers
During the turning process, we have investigated the problems that can arise, such as avoiding the formation of flow chips, which are eliminated by sawing the workpiece longitudinally. Furthermore, we measured the main cutting forces acting on the blade and the cutting forces in the feed direction a...
Elmentve itt :
| Szerzők: | |
|---|---|
| Dokumentumtípus: | Cikk |
| Megjelent: |
University of Szeged, Faculty of Engineering
Szeged
2024
|
| Sorozat: | Analecta technica Szegedinensia
18 No. 3 |
| Kulcsszavak: | Polimerek - megmunkálás, Anyagtudomány |
| Tárgyszavak: | |
| doi: | 10.14232/analecta.2024.3.19-27 |
| Online Access: | http://acta.bibl.u-szeged.hu/87044 |
| LEADER | 01949nab a2200253 i 4500 | ||
|---|---|---|---|
| 001 | acta87044 | ||
| 005 | 20250416151308.0 | ||
| 008 | 250416s2024 hu o 000 eng d | ||
| 022 | |a 2064-7964 | ||
| 024 | 7 | |a 10.14232/analecta.2024.3.19-27 |2 doi | |
| 040 | |a SZTE Egyetemi Kiadványok Repozitórium |b hun | ||
| 041 | |a eng | ||
| 100 | 1 | |a Kovács Róbert | |
| 245 | 1 | 0 | |a Investigation the machining of the engineering polymers |h [elektronikus dokumentum] / |c Kovács Róbert |
| 260 | |a University of Szeged, Faculty of Engineering |b Szeged |c 2024 | ||
| 300 | |a 19-27 | ||
| 490 | 0 | |a Analecta technica Szegedinensia |v 18 No. 3 | |
| 520 | 3 | |a During the turning process, we have investigated the problems that can arise, such as avoiding the formation of flow chips, which are eliminated by sawing the workpiece longitudinally. Furthermore, we measured the main cutting forces acting on the blade and the cutting forces in the feed direction at different feed rates, depths of grip and cutting speeds, and investigated possible correlations between these. Chips produced at different cutting parameters and with different materials were investigated. All turning operations are carried out without emulsion and all other coolants for environmental and other reasons. The specific cutting resistances have been determined, which are essential for determining good tool utilisation and also for planning the economics of machining The aim of this research is to define machining parameters that can be used in practice for the engineering plastics under investigation, so that the machining of these materials by turning can be made more economical. | |
| 650 | 4 | |a Műszaki és technológiai tudományok | |
| 650 | 4 | |a Anyagmérnökség | |
| 695 | |a Polimerek - megmunkálás, Anyagtudomány | ||
| 700 | 0 | 1 | |a Korzenszky Péter |e aut |
| 700 | 0 | 1 | |a Keresztes Róbert |e aut |
| 856 | 4 | 0 | |u http://acta.bibl.u-szeged.hu/87044/1/engineering_2024_003_019-027.pdf |z Dokumentum-elérés |